E2S-W11 Replacement Inductive Proximity Sensor, 1M Cable, 12-24 VDC

Replacement sensor for E2S-W11, listed with a 1 m cable and 12–24 VDC supply. Supplied as one sensor.

Manufacturer model reference

• Switching: Wired DC 2-wire, normally open (NO), with a physical cable connection.
• Detection: top sensing surface; nominal 1.6 mm sensing distance, with a 0–1.2 mm setting distance.
• Target: ferrous metal. Non-ferrous targets reduce the sensing distance.
• Connection check: confirm the load/input requirements and wiring for a two-wire sensor before connecting to a PLC.

Choose the correct E2S version

E2S-W12 is normally closed; E2S-Q11 senses from the front. E2S-W13 and E2S-W15 are three-wire NPN and PNP versions respectively, so they are not the same electrical configuration as E2S-W11. Match the complete model, sensing direction, cable termination and control input before ordering.

E2S reference-model specifications · E2S model-selection table

E2S model reference (PDF). Match the complete model and connection; this manufacturer reference does not verify the supplied item.