EE-SX676P-WR Slot Photomicrosensor (Replacement) - PNP Pre-wired, 5 mm Slot, 1 m Cable

This listing is for a slot-type photomicrosensor intended as a replacement for EE-SX676P-WR (EE-SX series). The pre-wired WR configuration includes an approximately 1 m cable to simplify installation. The sensor uses a through-beam slot design with a 5 mm sensing width and an infrared LED emitter (≈940 nm) to detect small opaque objects. The PNP open-collector output is compatible with 5-24 VDC systems and exhibits low residual voltage (~1.3 V at 50 mA). Before purchase and installation, confirm the model code, output polarity (PNP vs. NPN), and wiring to ensure electrical compatibility with your equipment.

• Replacement for EE-SX676P-WR (EE-SX series) slot photomicrosensor - designed to fit EE-SX67x family devices when output type and wiring match; verify model before ordering.
• Pre-wired WR variant with approximately 1 m cable for straightforward swap-in installation without additional connectors.
• PNP open-collector output; compatible with 5-24 VDC control circuits. Low residual voltage (about 1.3 V at 50 mA) suitable for common I/O.
• Through-beam slot sensor with a 5 mm slot width; detects small opaque targets down to roughly 2 × 0.8 mm. Infrared LED emitter (~940 nm) with selectable Dark-ON/Light-ON operation.
• What’s included: 1 x slot photomicrosensor (EE-SX676P-WR). Images show model marking and pre-wired cable; confirm any additional accessories with the seller.